10-64 Vehicle Care
A. Hoist Assembly
B. Hoist Shaft
C. Hoist Shaft Access Cover/Hole
D. Jack Handle Extensions
E. Wheel Wrench
F. Hoist Cable
G. Tyre/Wheel Retainer
H. Spare Tyre/Flat Tyre (Valve
Stem Pointed Down)
I. Hoist Shaft Access Hole
J. Hoist End of Extension Tool
K. Spare Tyre Lock
1. Put the tyre (H) on the ground at
the rear of the vehicle with the
valve stem pointed down and to
the rear.
2. Tilt the tyre toward the vehicle.
Separate the tyre/wheel retainer
(G) from the guide pin. Pull the
pin through the centre of the
wheel. Tilt the retainer down and
through the centre wheel
opening.
3. Assemble the two jack handle
extensions (D) and wheel
wrench (E) as shown.
To Next Page
Loading...
