10-30 Vehicle Care
4. Install the bulb socket in the
headlamp assembly.
5. For the driver side, reinstall the
underhood electrical center
cover by latching three clips.
6. For the passenger side, reinstall
the air filter/cleaner assembly
base by pushing to seat. Verify
the base is seated securely, then
install the engine air filter/
cleaner assembly.
Turn Signal Lamps
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2-13.
2. Remove the push pin (1) on the
taillamp cover (2).
3. Remove the taillamp cover from
the lamp assembly by pulling
rearward from the top to
unfasten the snap tabs.
4. Remove the two screws from the
taillamp assembly.
5. Pull the taillamp assembly
straight back to remove.
To Next Page
Loading...
