In Brief 1-15
5 : Turns on the headlamps
together with the parking lamps and
instrument panel lights.
See:
.
Exterior Lamp Controls on
page 6-1
.
Daytime Running Lamps (DRL)
on page 6-4
.
Automatic Headlamp System on
page 6-4
Windscreen Wiper/
Washer
The windscreen wiper control is on
the indicator lever.
The windscreen wipers are
controlled by turning the band with
z FRONT on it.
1 : Fast wipes.
w : Slow wipes.
3 INT: Turn the z FRONT band
up for more frequent wipes or down
for less frequent wipes.
OFF: Turns the windscreen
wipers off.
8 : For a single wipe, turn to 8,
then release. For several wipes,
hold the band on
8 longer.
L m : Push the paddle at the top of
the lever to spray washer fluid on
the windscreen.
Rainsense™
With Rainsense, a sensor near the
top centre of the windscreen detects
the amount of water on the
windscreen and controls the
frequency of the windscreen wiper.
3 INT: Turn the z FRONT
band on the wiper lever to adjust the
sensitivity when Rainsense is
turned on.
.
Turn the band up to a higher INT
setting for more sensitivity to
moisture.
.
Turn the band down to the lower
INT setting for less sensitivity to
moisture.
Move the band out of the
3 INT
position to deactivate Rainsense.
z AUTO: Press to turn
Rainsense on or off. When turned
on and
z FRONT is in one of the
Rainsense wipe sensitivity
positions, the wipers can be
adjusted for more or less sensitivity
to moisture. When turned off, the
wipers operate as timed intermittent
wipers and can be adjusted for
more or less frequent wipes. A DIC
message may be displayed when
Rainsense is turned on or off.
To Next Page
Loading...
