10-26 Vehicle Care
2. Lift up on the latch in the middle
of the wiper blade where the
wiper arm attaches.
3. With the catch open, pull the
wiper blade down towards the
windscreen far enough to
release it from the J-hooked end
of the wiper arm.
4. Remove the wiper blade.
Allowing the wiper blade arm to
touch the windscreen when no
wiper blade is installed could
damage the windscreen. Any
damage that occurs would not
be covered by the vehicle
warranty. Do not allow the wiper
blade arm to touch the
windscreen.
5. Reverse Steps 1–3 for wiper
blade replacement.
Rear Wiper Blade Replacement
To replace the rear wiper blade:
1. Pull the wiper blade assembly
away from the back glass.
The rear wiper blade will not lock
in a vertical position so care
should be used when pulling it
away from the vehicle.
2. Push the release lever (2) to
disengage the hook and push
the wiper arm (1) out of the
blade assembly (3).
3. Push the new blade assembly
securely in the wiper arm hook
until the release lever clicks into
place.
4. Return the wiper arm and blade
assembly to the rest position on
the glass.
Glass Replacement
If the windscreen or front side glass
must be replaced, see your dealer
to determine the correct
replacement glass.
Windscreen Replacement
The windscreen is part of the HUD
system. If the vehicle has to have
the windscreen replaced, get one
that is designed for HUD or the
HUD image may look out of focus.
To Next Page
Loading...
