10-72 Vehicle Care
3. Remove the spare tire cover.
4. Remove the rubber cover.
5. Remove the nut retaining the
spare tire.
6. Remove the spare tire and place
it next to the tire being changed.
7. Remove the wing nut.
8. Remove the extension, jack, and
wheel wrench and place them
near the tire being changed.
Removing the Flat Tire and
Installing the Spare Tire
Take off the wheel cover or center
cap, if the vehicle has one, to reach
the wheel bolts.
1. Do a safety check before
proceeding. See If a Tire Goes
Flat on page 10-62 for more
information.
2. Turn the wheel wrench
counterclockwise to loosen and
remove the wheel nut caps.
Do not try to remove plastic caps
from the cover or center cap.
3. Pull the cover or center cap
away from the wheel. Store the
wheel cover in the cargo area
until you have the flat tire
repaired or replaced.
To Next Page
Loading...
