34 Keys, Doors, and Windows
5. Open the trunk.
6. Turn the key counterclockwise
five times within 10 seconds.
7. The DIC displays READY FOR
REMOTE KEY 3 or 4, up to 8.
8. Remove the rubber liner to
access the pocket. Place the
new transmitter, button side
down, on the indent in the
center console storage area.
9. Press POWER
O.
10. The DIC displays READY FOR
REMOTE KEY 4 or 5, up to 8.
11. Press
Q or K on each newly
programmed transmitter to
complete the process.
12. To program additional
transmitters, repeat
Steps 8–11.
Return the key base back into
the RKE transmitter.
13. Press and hold POWER
O for
at least 12 seconds to exit
programming.
Programming without a
Recognized Transmitter
If there are no currently recognized
transmitters available, follow this
procedure to program up to eight
transmitters. This feature is not
available in Canada. This procedure
will take approximately 30 minutes
to complete. The vehicle must be off
and all transmitters to be
programmed must be present.
1. Remove the key from the
transmitter and insert the
vehicle key into the key
cylinder above the license
plate.
2. Open the trunk.
3. Turn the key counterclockwise
five times within 10 seconds.
The DIC message displays
REMOTE LEARN PENDING
PLEASE WAIT.
4. Return the key base back into
the RKE transmitter.
To Next Page
Loading...
