54 Seats and Restraints
{
Warning
Sitting in a reclined position when
the vehicle is in motion can be
dangerous. Even when buckled
up, the safety belts cannot do
their job.
The shoulder belt will not be
against your body. Instead, it will
be in front of you. In a crash, you
could go into it, receiving neck or
other injuries.
The lap belt could go up over
your abdomen. The belt forces
would be there, not at your pelvic
bones. This could cause serious
internal injuries.
For proper protection when the
vehicle is in motion, have the
seatback upright. Then sit well
back in the seat and wear the
safety belt properly.
Do not have a seatback reclined if
the vehicle is moving.
Memory Seats
The SET, 1, 2, and B (Exit) buttons
on the driver door are used to
manually store and recall memory
settings for the driver seat, outside
mirrors, and power tilt and
telescoping steering column.
Storing Memory Positions
To store positions to the 1 and 2
buttons:
1. Ignition must be in ON/RUN or
ACC/ACCESSORY.
2. Adjust the driver seat, outside
mirrors, and the power tilt and
telescoping steering column to
the desired driving positions.
3. Press and release SET. A beep
will sound.
4. Immediately press and hold 1
until two beeps sound.
5. Repeat Steps 1–4 for a second
driver using 2.
To store exit positions and easy exit
features to the
B (Exit) button,
repeat Steps 1–4 using
B to store
your positions for getting out of the
vehicle.
To Next Page
Loading...
