INFOTAINMENT SYSTEM 161
session is active. If “Phone” or “Phone
Commands” is spoken, the system
understands that a phone call is
requested and will respond with
questions until enough details are
gathered to make a call.
If a cell phone number has been saved
with a name and a place, the direct
command should include both, for
example “Call <name> at work.”
Using Voice Recognition for List
Options
When a list is displayed, a voice
prompt will ask to confirm or select
an option from that list.
When a display contains a list, there
may be options that are available but
not displayed. The list on a voice
recognition screen functions the same
as a list on other displays. Scrolling or
flinging can be used to help display
other entries from the list.
Manually scrolling or paging the list
on a display during a voice
recognition session suspends the
current voice recognition event and
plays the prompt “Please select
manually or touch the Back icon on
the infotainment display to tr y again.”
If manual selection takes more than
15 seconds, the session terminates
and prompts that it has timed out.
The display returns to the display
where voice recognition was initiated.
The Back Command
Say “Back” or touch the Back icon on
the infotainment display to go to the
previous display.
If in voice recognition, and “Back” is
spoken all the way back to the
starting display, and then “Back” is
spoken one more time, the voice
recognition session will cancel.
Help
Say “Help” on any voice recognition
display and the help prompt for the
display is played.
Touching
g while the help prompt is
playing will terminate the prompt.
Doing this will stop the help prompt
so that a voice command can be used.
Voice Recognition for the Radio
If browsing the audio sources when
voice is touched, the voice recognition
commands for AM, FM, and DAB (if
equipped) are available.
“Switch to AM” : Switch bands to AM
and tune to the last AM radio station.
“Switch to FM” : Switch bands to FM
and tune to the last FM radio station.
“Switch to DAB” : Switch bands to
DAB and tune to the last DAB radio
station.
“Tune to <AM frequency> AM” :
Tune to the radio station whose
frequency is identified in the
command (like “nine fifty”).
“Tune to <FM frequency> FM” : Tune
to the radio station whose frequency
is identified in the command (like
“one oh one point one”).
“Tune to <DAB station name>
DAB” : Tune to the radio
station name.
To Next Page