KEYS, DOORS, AND WINDOWS 17
Driver Door Key Lock Cylinder
Access (In Case of Dead Battery)
To access the driver door key lock
cylinder and unlatch the door:
1. Insert the mechanical key into
the slot at the bottom of the
handle and push upward all the
way until the cover frees. Do not
pry or pull on the key.
2. Remove the cover.
3. Insert the mechanical key in the
cylinder.
4. Turn the mechanical key
clockwise until it stops.
5. Slowly turn the mechanical key
counterclockwise while pulling
the handle to unlatch the door.
6. Repeat steps 4 and 5 if the door
does not fully open.
To replace the cap:
1. Align the top edge of the cover
to the handle.
2. Turn downward to snap cover
into position.
3. Check to ensure cap is fully
seated.
To Next Page
Loading...
