18
Driver Mode Control auto-
matically adjusts the steering,
suspension, and powertrain
calibrations in real time.
Press the MODE buon on
the center console to select
the Tour (default at each
ignition cycle), Sport, or
Snow/Ice mode.
Note: For information on Driver
Modes on the CT6 PLUG-IN, refer to
your CT6 PLUG-IN Convenience & Personalization Guide.
See Driving and Operating in your Owner’s Manual.
DRIVER MODE CONTROL
e traction control system limits wheelspin and the StabiliTrak
stability control system assists with directional control of the
vehicle in dicult driving conditions. Both systems turn on auto-
matically every time the vehicle is started. Turn o traction control
if the vehicle is stuck, and rocking the vehicle is required.
Press the Traction Control/StabiliTrak OFF buon on the
center console. e Traction Control O light will illuminate
on the instrument cluster. Press the buon again to turn on
traction control.
See Driving and Operating in your Owner’s Manual.
TRACTION CONTROL AND
STABILITRAK
®
SYSTEMS
TAP SHIFT AUTOMATIC
TRANSMISSION
e automatic transmission has paddle
shiers on the steering wheel and a Manual
mode that allows you to shi gears similar
to a manual transmission.
To temporarily take control of gear selection while in Drive (D),
use either paddle behind the steering wheel. Automatic shiing
returns aer the accelerator pedal is held steady for 6 seconds.
To enter Permanent Tap Shi Mode, move the shi lever to
Manual (M). Use the paddles to manually shi the transmission.
Shi to Drive to return to automatic shiing.
In either mode, pull the right paddle to upshi or the le paddle
to downshi. e current gear will be displayed on the instru-
ment cluster.
If current speed is too high or too low for the requested gear, the shi
will not occur. SHIFT DENIED will display on the instrument cluster.
Note: For information on using the paddle shifters for Regen on Demand on
the CT6 PLUG-IN, refer to your CT6 PLUG-IN Convenience & Personalization
Guide.
See Driving and Operating in your Owner’s Manual.