3. Press the power/volume knob to turn on the
navigation and audio systems.
4. Press the MAIN key to access the DIC
main menu.
5. Press the reconfigurable key next to Feat Prog
to access the Feature Programming menu.
6. Press the TUNE/SEL knob to turn on the
Personalization features. An X will appear
in the box when Personalization is turned on.
Personalization Features
The following choices are available for
programming:
Personalization Name
This feature allows you to type in a name that will
appear on the DIC display whenever the
corresponding remote keyless entry transmitter is
used or one of the buttons on the driver’s door
armrest (1 or 2) is pressed.
If a customized name is not programmed, the
system will show Driver 1 or Driver 2 to correspond
with the numbers on the back of the remote
keyless entry transmitters.
To program a name, do the following:
1. Enter the Personalization menu following the
instructions listed previously.
2. Turn the TUNE/SEL knob until Personalization
Name is highlighted. Press the knob once to
access the Edit Name screen.
3. Use the alpha-numeric keypad at the bottom
of the screen. See “Alpha-Numeric Keypad”
under Using the Navigation System on
page 22 for more information.
4. Repeat Step 3 until the name entry is
complete. You can enter up to 26 characters.
5. Press the OK reconfigurable key to save it.
The name you selected is now set. You can either
exit the programming mode by following the
instructions later in this section or program the
next feature available on your vehicle.
103
To Next Page
Loading...
