Playing the Radio
BAND: Press the BAND key once to access the
audio system. You can also access the audio
system from the Navigation Main Menu. See Main
Menu on page 9.
PWR/VOL (Power/Volume): Press this knob to
turn the Navigation System on and off.
Turn the knob to increase or decrease the volume
level. You can also adjust the volume level
using the steering wheel controls, if equipped. See
“Audio Steering Wheel Controls” in the Index of
your vehicle’s owner manual for more information.
Finding a Station
BAND: After you access the main radio display,
press this button repeatedly to scroll through
the bands: AM, FM1, FM2, XM1 and XM2,
if equipped. The one currently selected is shown
near the top of the display.
TUNE/SEL (Select): Use this knob to manually
tune the radio, access the radio menus, and scroll
through the menu items. See “FM Menu” listed
previously in this section for more information on
the menu items.
oSEEK/SCAN p: Press the left or right arrow
to go to the previous or next station and stay
there. The volume will mute while seeking.
To scan stations, press and hold the left or right
arrow for two seconds until you hear a beep.
The radio will go to the next or previous station,
play for a few seconds, then go on to the next
station. The volume will mute while scanning.
Press either arrow again to stop scanning.
To scan preset radio stations, press and hold the
right arrow for more than four seconds. You
will hear two beeps and Preset Scan will appear
on the screen. The radio will go to the first
preset station stored, play for a few seconds, then
go on to the next preset station. The volume
will mute while scanning. Press the left or right
arrow again to stop scanning presets. See “Setting
Preset Stations” later in this section for more
information.
The radio will seek or scan stations with a strong
signal only.
70
To Next Page
Loading...
