Tire Sealant and Compressor Kit
(Without Sealant Selector Switch)
Your vehicle has a tire sealant and compressor kit that
is capable of temporarily sealing a small puncture up to
6 mm in the tread. There is no jack or spare tire. The kit
inflates the tire with liquid sealant and air. The tire sealant
and compressor kit can also be used to inflate an
underinflated tire. After the tire is inflated to the
recommended inflation pressure, see Inflation - Tire
Pressure on page 5-66, the vehicle must be driven for
five miles to distribute the sealant in the tire and seal the
puncture. After driving five miles the tire pressure must be
rechecked and adjusted as needed. See “Using the Tire
Sealant and Compressor Kit to Temporarily Seal and
Inflate a Punctured Tire” later in this section. Be sure to
read and follow all of the tire sealant and compressor kit
instructions. The kit includes:
After temporarily repairing the tire sealant and
compressor kit, it is recommended to take your vehicle to
an authorized dealer/retailer as soon as possible. If the
sealant is removed within 100 miles (161 kilometers)
of driving, then it is easier to clean from the tire and
you are less likely to require a replacement tire.
A. Air Compressor
B. Tire Sealant Canister
C. Air Compressor
Accessory Plug
D. On/Off Switch
E. Air Pressure Gage
F. Air Only Hose
G. Sealant/Air Hose
5-93
To Next Page
Loading...
