Add Waypoint
Add: Select this screen button from the Route screen.
This feature allows up to three waypoints to be
added to the current route, between one start point and
final destination. Once a waypoint has been added,
the points can be edited or deleted.
To add a waypoint:
1. Press the DEST hard key.
2. Select the Add screen button. This button only
appears if a route has been calculated.
3. Using the desired method of entering a destination,
enter the waypoint. See “Destination” previously for
more information. The system calculates and
highlights the route. The route is now ready to be
started.
4. To add more waypoints, press the DEST hard key,
then select the Add screen button, where the next
waypoint should fall on the route. The system
calculates and highlights the route. The route is now
ready to be started.
To delete a waypoint:
1. Press the DEST hard key.
2. Select the Delete screen button next to the waypoint
to be deleted.
3. The system displays a pop-up confirmation
message. Select Yes to delete the waypoint; select
No to cancel this operation. The system calculates
and highlights the route. The route is now ready
to be started.
Suspend Guidance
Press this screen button, from the Route screen, to put
the current route on hold.
Resume Guidance
Press this screen button, from the Route screen, to
resume guidance on the current route.
2-23
To Next Page
Loading...
