Navigation Audio System
Notice: Before adding any sound equipment to the
vehicle, such as an audio system, CD player, CB
radio, mobile telephone, or two-way radio, make sure
that it can be added by checking with your dealer/
retailer. Also, check federal rules covering mobile
radio and telephone units. If sound equipment can be
added, it is very important to do it properly. Added
sound equipment can interfere with the operation of
the vehicle’s engine, radio, or other systems, and
even damage them. The vehicle’s systems can
interfere with the operation of sound equipment that
has been added.
Notice: The chime signals related to safety belts,
parking brake, and other functions of the vehicle
operate through the navigation system. If that
equipment is replaced or additional equipment is
added to the vehicle, the chimes may not work.
Make sure that replacement or additional equipment
is compatible with the vehicle before installing it.
See “Accessories and Modifications” in the Index of
the vehicle’s owner manual.
Playing the Radio
O
(Power/Volume): Press to turn the audio system
on and off. Turn the knob to increase or to decrease the
volume.
TUNE/TONE Knob: Turn to go to the next or previous
frequency.
Press this knob to display the Sound menu. See “Sound
Menu” later in this section.
AUDIO: Press to display the full audio screen. Press
the key to switch between AM, FM, or XM™, if
equipped, CD, DVD, HDD, and AUX (auxiliary input), or
touch the screen button. See CD Player on page 3-10,
DVD Player on page 3-16, Hard Drive Device on
page 3-22, and Auxiliary Devices on page 3-28 for
more information.
3-2
To Next Page
Loading...
