Keys, Doors, and Windows 1-9
The vehicle comes with two
transmitters. Each transmitter
will have a number on top of it,
“1” or “2”. These numbers
correspond to the driver of the
vehicle. For example, the memory
seat position for driver 1 will be
recalled when using the transmitter
labeled “1”, if enabled through
the DIC. See Memory
Seats on page 2‑9 and Vehicle
Personalization on page 4‑51
for more information.
Programming Transmitters
to the Vehicle
Only keyless access transmitters
programmed to the vehicle will work.
If a transmitter is lost or stolen, a
replacement can be purchased and
programmed through your dealer.
The vehicle can be reprogrammed
so that lost or stolen transmitters no
longer work. Each vehicle can have
up to four transmitters matched to it.
Programming with a Recognized
Transmitter
A new transmitter can be
programmed to the vehicle when
there is one recognized transmitter.
1. The vehicle must be off.
2. Place the recognized
transmitter(s) in the cupholder.
Have the new transmitter
available with you.
3. Insert the vehicle key into the
key lock cylinder located on the
outside of the driver door.
4. Turn the key to the unlock
position five times within
five seconds.
5. The Driver Information
Center (DIC) displays READY
TO LEARN ELECTRONIC
KEY #2, 3 OR 4.
6. Place the new transmitter into
the transmitter pocket with the
buttons facing the front of the
vehicle. The transmitter pocket
is inside the center console
storage area located between
the driver and front passenger
seats.
To Next Page
Loading...
