Keys, Doors, and Windows 2-23
To avoid setting off the alarm by
accident, lock the vehicle with the
door key after the doors are closed,
and always unlock a door with the
transmitter or by using the key in the
driver door cylinder. Unlocking a
door any other way will set off the
alarm.
If you set off the alarm by accident,
turn off the alarm by pressing the
unlock button on the transmitter.
How to Detect a Tamper
Condition
If K is pressed and the horn chirps
three times, an attempted break-in
has occurred while the system was
armed.
If the alarm has been activated, the
“Theft Attempted” message will
appear on the DIC. See Security
Messages on page 5‑44 for
additional information.
Intrusion Sensor
The vehicle's intrusion sensor
monitors the vehicle interior and
provides an alarm signal to the theft
deterrent module in the event of an
unauthorised entry into the vehicle's
interior. Do not allow passengers or
pets to remain in the vehicle when
the intrusion sensor is activated.
Before arming the theft deterrent
system and activating the intrusion
sensor, do the following.
.
Make sure all doors, windows
and the sunroof (if equipped) are
completely closed.
.
Turn off any fans or blowers.
Moving air may trigger the alarm.
.
Be sure to secure any loose
items such as a sunshade or
window blinds.
.
Make sure there are no
obstructions blocking the
sensors in the front overhead
console.
.
Do not hang anything from the
rear view mirror.
If any passengers must remain in
the vehicle, they should lock the
doors from inside using the power
door lock switch after the doors
have been closed. The intrusion
sensor will not be activated.
Anti-theft Locking System
The vehicle is equipped with a
deadbolt locking feature in addition
to the standard door locks.
If the vehicle has the keyless
access system, the deadbolt is
engaged whenever you press
Q on
the keyless access transmitter twice
within five seconds.
To Next Page
Loading...
