1-3
Memory Seat and Memory Mirrors
The memory function controls are located on the
driver’s door trim panel.
For this function to work, it must be enabled/configured
in the Secondary Information Center (SIC).
See “Secondary Information Center” in the Index
for more information.
These buttons are used to program and recall the
memory settings for the driver’s seat and both
the driver’s and the passenger’s outside mirrors.
The seat and mirror positions can be personalized
for both driver 1 and driver 2. Driver 1 or driver 2
corresponds to the memory buttons labeled 1 and 2
on the control.
The memory function does not store the lumbar or
back support positions.
To set your memory seat and mirrors do the following:
1. Adjust the driver’s seat and both outside mirrors to
the desired position.
2. Press and hold the 1 or 2 (driver 1 or 2) button of the
memory control for three seconds. When you hear a
chime ring two times, the memory position is stored.
To do the same thing for a second driver, follow the
preceding steps, but press the other number of the
memory control. The memory feature only works when
the transmission is in PARK (P).
To Next Page
Loading...
