Cadillac LYRIQ 2024 - Starting and Stopping the Vehicle

Cadillac LYRIQ Owner Manual (GMNA-Localizing-Europe-16878479) -
2024 - CRC - 9/20/23
Driving and Operating 159
Caution (Continued)
wear and earlier replacement. Follow this
breaking-in guideline every time you get
new brake linings. Following run-in,
vehicle speed and load can be gradually
increased.
Power Button
The vehicle has an electronic pushbutton
start.
The Remote Key must be in the vehicle for
the system to operate. If the vehicle will not
start, place the Remote Key in the
transmitter pocket, inside the centre console.
ON/RUN : This position is for starting and
driving. With the vehicle off, and the brake
pedal applied, pressing POWER
O once will
place the vehicle in ON/RUN. When the
vehicle ready light is on in the instrument
cluster, the vehicle is ready to be driven.
This could take up to 15 seconds at
extremely cold temperatures.
Service Mode
This power mode is available for service and
diagnostics, and to verify the proper
operation of the service vehicle soon light as
may be required for inspection or
maintenance purposes. With the vehicle off,
and the brake pedal not applied, pressing
and holding POWER
O for more than
five seconds will place the vehicle in Service
Mode. The instruments and audio systems
will operate as they do in ON/RUN, but the
vehicle will not be able to be driven. The
propulsion system will not start in Service
Mode. Press POWER
O again to turn the
vehicle off.
Caution
Placing the vehicle in Service Mode will
use the 12-volt battery. Do not use
Service Mode for an extended period,
or the vehicle may not start.
STOPPING THE VEHICLE/OFF : To turn the
vehicle off, apply the brakes, press the
button on top of the gear lever to shift to
P (Park) and press POWER
O.
Alternatively, apply the brakes and press
POWER
O. The electric drive unit will shift
to P (Park) then shut off automatically.
Retained Accessory Power (RAP) will remain
active until the driver door is opened.
If the vehicle must be shut off in an
emergency:
1. Brake using a firm and steady pressure.
Do not pump the brakes repeatedly. This
may deplete power assist, requiring
increased brake pedal force.
2. Shift the vehicle to N (Neutral). This can
be done while the vehicle is moving.
After shifting to N (Neutral), firmly apply
the brakes and steer the vehicle to a
safe location.