Cadillac LYRIQ Owner Manual (GMNA-Localizing-Europe-16878479) -
2024 - CRC - 9/20/23
Driving and Operating 165
D : This position is for normal driving.
If more power is needed for overtaking,
press the accelerator pedal down.
To shift into D (Drive):
1. Bring the vehicle to a complete stop.
2. From the centre position, move the gear
lever rearward toward you and
then down.
.
If the vehicle is in P (Park), press the
brake pedal while moving the gear
lever.
.
D will illuminate red.
3. After releasing the gear lever, it will
return to the centre position.
To shift out of D (Drive):
1. Bring the vehicle to a complete stop.
2. Shift to the desired gear.
Caution
Spinning the tyres excessively may
damage the electric drive unit. The repair
will not be covered by the vehicle
warranty. If you are stuck, do not spin
the tyres.
When stopping on a steep hill, use the
brakes to hold the vehicle in place.
When shifting to P (Park) on a hill, use the
brakes to hold the vehicle then shift to
P (Park).
One-Pedal Driving
One-Pedal Driving allows the use of the
accelerator pedal to control the deceleration
of the vehicle to a complete stop.
Completely releasing the accelerator pedal
will result in aggressive deceleration.
Partially lifting off the accelerator pedal
allows the deceleration of the vehicle to be
adjusted as desired.
Use the brake pedal if emergency braking is
required.
To view and configure One-Pedal Driving,
from the infotainment display home screen,
Select Controls > Drive & Park > One-Pedal
Driving.
Select Off to disable One-Pedal Driving for
traditional two-pedal driving, similar to a
petrol vehicle.
Select On to enable One-Pedal Driving where
a moderate level of braking is applied when
the accelerator pedal is released while
driving.
Select High to enable One-Pedal Driving
where a strong level of braking is applied
when the accelerator pedal is released while
driving.
When enabled, One-Pedal Driving applies in
R (Reverse) and D (Drive). This feature
remains enabled until manually disabled by
the driver. Press the accelerator pedal to the
desired speed. The brake lights will come on
during substantial deceleration and when
the vehicle is stopped.
If One-Pedal Driving is turned off while
stopped, the vehicle will stay stopped. Press
the brake pedal or accelerator pedal to
return to two-pedal driving.
For faster access, One-Pedal Driving can be
toggled on the Driver Mode screen. From
the infotainment display home screen, select
Drive Mode to open the Drive Mode screen.
Touch
l to toggle One-Pedal Driving on or
off. When turned on, One-Pedal Driving
returns to the previously selected level. To
change the level, press the Settings link in
the pop-up box to go to the full One-Pedal
Driving selection.
When possible, One-Pedal Driving uses
regenerative braking to slow the vehicle for
energy efficiency. Friction brakes may be
To Next Page
Loading...
