Cadillac LYRIQ 2024 - Forward Collision Alert (FCA) System

Cadillac LYRIQ Owner Manual (GMNA-Localizing-Europe-16878479) -
2024 - CRC - 9/20/23
196 Driving and Operating
.
Press and hold the thumbwheel down to
SET− to decrease the set speed by 5 km/h
(5 mph). Release the thumbwheel when
the desired set speed is displayed in the
instrument cluster.
When using Speed Limiter in Auto mode,
there is a predefined minimum allowed
value of offset beyond which the set speed
cannot be decreased.
Accept or Decline Automatic Set Speed
Changes (Auto)
When Speed Limiter is in Auto mode, is
active, and a new speed limit sign is
detected, it will propose a new set speed
based on the detected speed limit sign. The
proposed new set speed will be displayed as
a message in the instrument cluster.
.
To accept the new set speed, briefly
move the thumbwheel down to SET− and
release it.
.
To decline the new set speed, briefly
move the thumbwheel up to RES+ and
release it.
If you do not accept or decline the new
proposed set speed, there is no change to
the set speed.
Conditions Affecting Automatic Speed
Limiter (Auto)
.
There are changes in brightness, such as
entering and exiting tunnels, bridges, and
overpasses.
.
There are low sun angles.
.
Ambient lighting is poor in the evening or
early morning.
.
There are multiple changes in brightness
or there are shadows along the roadway.
.
There are conditions associated with low
visibility such as mist, rain, snow, or road
spray.
.
The on-board camera's view of the road is
blocked by leaves, snow, or other debris.
If Automatic Speed Limiter becomes
temporarily unavailable, change to
Manual mode.
Resuming Speed Limiter
If Speed Limiter was active but then
* was
pressed, Speed Limiter can be resumed using
the previous set speed. Briefly move the
thumbwheel up to RES+ and release it to
activate Speed Limiter using the previous set
speed.
If Speed Limiter was turned off because
cruise control, ACC, or Super Cruise was
turned on, to use Speed Limiter again:
1. Turn off cruise control, ACC, or Super
Cruise.
2. On the infotainment home screen, touch
Controls > See More Controls > Drive &
Park > Speed Limiter.
3. Select Manual or Auto.
Overriding Speed Limiter
When Speed Limiter is active, the set speed
can be temporarily overridden only when
you fully apply the accelerator pedal. You
can control vehicle acceleration again when
the vehicle speed is below the set speed.
Turning Off Speed Limiter
To turn off Speed Limiter, from the
infotainment home screen, touch Controls >
See More Controls > Drive & Park > Speed
Limiter > Off.
Forward Collision Alert (FCA)
System
The FCA system may help to avoid or
reduce the harm caused by front-end
crashes. When approaching a vehicle ahead
too quickly, FCA provides a red flashing alert