Cadillac LYRIQ Owner Manual (GMNA-Localizing-Europe-16878479) -
2024 - CRC - 9/20/23
72 Seats and Restraints
If the child restraint is installed next
to a centre seat, make sure the top
tether does not interfere with the
centre seating position shoulder belt/
retractor. If it does, find another
suitable seating position to install the
child restraint.
2. Make sure the child restraint top tether
hook is completely closed and secured to
the top tether anchor.
Securing Child Restraints
The rear seats are the most convenient
location to fasten a child restraint. See
Where to Put the Restraint 0 65.
Infants and children should be placed in the
rear seat and properly restrained, according
to the terms in this manual.
{
Danger
NEVER use a rearward-facing child
restraint on a seat protected by an
ACTIVE AIRBAG in front of it; DEATH or
SERIOUS INJURY to the CHILD can occur.
{
Danger
If using a rear-facing child restraint on
the front passenger seat, the airbag for
the front passenger seat must be
deactivated. This also applies to certain
forward-facing child restraints as indicated
in the tables listed in this manual.
See Airbag On-Off Switch 0 55.
If the child restraint uses a top tether, see
Where to Put the Restraint 0 65 for top
tether anchor locations.
Do not secure a child restraint in a position
without a top tether anchor if a national or
local law requires that the top tether must
be anchored, or if the instructions that come
with the child restraint say that the top
tether must be anchored.
When using the lap-shoulder belt to secure
the child restraint in this position, follow the
instructions that came with the child
restraint and the following instructions:
1. Put the child restraint on the seat.
2. Pick up the latch plate and run the lap
and shoulder portions of the vehicle seat
belt through or around the child
restraint. Ensure the seat belt webbing is
routed as direct as possible, and is not
caught on seat handles or plastic trim.
The child restraint instructions will show
you how.
3. Push the latch plate into the buckle until
it clicks.
Position the release pushbutton on the
buckle, away from the child restraint
system, so that the seat belt could be
quickly unfastened if necessary.
The release pushbutton used to release
the latch plate must be visible and not
obscured by the child restraint. There
must not be direct contact of the child
restraint to the release pushbutton.
4. Follow the instructions in the child
restraint owner's manual to tighten and
lock the child restraint when using the
vehicle seat belt.
5. If the child restraint has a top tether,
follow the child restraint manufacturer's
instructions regarding the use of the top
tether. See ISOFIX Child Restraint Systems
0 70.
6. Before placing a child in the child
restraint, make sure it is securely held in
place. Push and pull the child restraint in
different directions to be sure it is
secure.
To Next Page
Loading...
