Adding Washer Fluid
The Check Washer Fluid message will appear on the
DIC when the fluid level is low. See DIC Warnings and
Messages on page 3-64 for more information.
The windshield washer fluid reservoir is located on the
passenger’s side of the vehicle near the front of the
engine compartment. See Engine Compartment
Overview on page 5-12 for more information on location.
Open the cap with the
washer symbol on it. Add
washer fluid until the
tank is full.
Notice:
• When using concentrated washer fluid, follow
the manufacturer’s instructions for adding
water.
• Do not mix water with ready-to-use washer fluid.
Water can cause the solution to freeze and
damage your washer fluid tank and other parts
of the washer system. Also, water does not
clean as well as washer fluid.
• Fill your washer fluid tank only three-quarters
full when it is very cold. This allows for
expansion if freezing occurs, which could
damage the tank if it is completely full.
• Do not use engine coolant (antifreeze) in your
windshield washer. It can damage your washer
system and paint.
5-39
To Next Page
Loading...
