MEMORY SEAT AND MIRRORS
(if equipped)
The buttons to set the seat and mirror
memory are located on the driver’s
armrest. To set the memory, first adjust
the driver’s seat, including the seatback
recliner, both outside mirrors, the
throttle and brake pedals, audio settings
and HVAC settings.
1. Press and hold button 1 until two
beeps are heard to confirm memory
setting.
2. Repeat the procedure using button 2
to store memory for a second driver.
Setting Exit Position
1. Press button 1 or the unlock symbol
on the keyless entry fob with number
1 on the back. Adjust the driver’s
seat to the desired exit position.
2. Press and hold the exit button,
located above buttons 1 and 2 on the
driver door armrest, until two beeps
are heard to confirm exit memory
setting. Repeat the procedure for a
second driver using button 2 and the
key fob with 2 on the back.
To recall stored exit positions, press and
release the exit button. A beep will
sound and the seat will move to the
memory exit position for the identified
driver. If no exit position is stored, the
seat will move all the way back.
Note: The vehicle must be in Park to
recall the exit position.
For further programming instructions for
seat and mirror memory, refer to your
Owner Manual or Personalization
Instructional CD and Booklet.
INSTRUMENT PANEL AND COURTESY
LIGHTS
Slide the lever in the overhead console
forward to brighten the panel lights and
past the resistance point to turn the
courtesy lights on. Slide the lever in the
opposite direction to turn off the
courtesy lights or dim the panel lights.
REAR WASHER/WIPER
The rear washer/wiper
control is located in the
overhead console. Press
the center of the switch to
wash the rear window.
Press the forward part of
the switch for delayed
wipes. Press the rear part
of the switch for steady wipes.
SRX
To Next Page
Loading...
