DVD Player
The player can be used for DVD audio and DVD video.
With the ignition on, insert a DVD partway into the
slot, located at the top of the system, label side up. The
player pulls it in and the DVD begins playing. While
playing a DVD, the navigation system is available. If a
DVD is inserted with the system off and the ignition on, it
starts to play.
This feature does not operate on the navigation screen
unless the vehicle is in PARK (P).
The Rear Seat Entertainment (RSE) video screen starts
play of the DVD when a DVD has been inserted into
the navigation system. See Rear Seat Entertainment
(RSE) System on page 3-22 for information on operating
the rear seat entertainment system.
The DVD player is only compatible with DVDs of the
appropriate region code that is printed on the jacket of
most DVDs.
The DVD slot is compatible with most audio CDs, CD-R,
CD-RW, DVD-Video, DVD-Audio, DVD-R/RW,
DVD+R/RW media along with MP3 and un-protected
WMA formats.
The navigation system can play digital recordings such
as Dolby Digital (AC-3), DTS, or MLP (DVD-A).
If an error displays, see “DVD Messages” later in this
section.
Playing a DVD
There are three ways to play a DVD:
• Once a DVD is inserted, the system automatically
starts play of the DVD.
• If you are on a map screen, touch the DVD screen
button.
• Press the AUDIO hard key, then touch the DVD
screen button.
While a DVD is playing in the DVD player, the rear seat
operator can power on the RSE video screen and
use the remote control to navigate through the DVD.
O (Power/Volume):
1. Press to turn the system on and off.
2. Turn the knob to increase or decrease the volume
of the audio system.
3. Press and hold this knob for more than two seconds
to turn the navigation system, RSE, and RSA off.
3-16
To Next Page
Loading...
