Storage 3-7
D-Ring Sliders
There are four D-Ring sliders that
move along rails on both sides of
the cargo management area. These
can be used as tie-downs when
storing cargo.
Installing D-Ring Sliders
To install the D-Ring slider (A),
insert it into the channel (B) located
in the middle of both rails.
The loop of the D-Ring slider must
be facing inward towards the
storage area and the ring must be in
the up position for proper usage.
Push the button to move the D-Ring
slider either towards the front or the
rear of the vehicle. The rings can be
locked into various positions along
the rail.
U-Rail
For vehicles with a U-Rail system,
move the gate around the u-shaped
track to store and secure cargo in
place.
To Next Page
Loading...
