10-44 Vehicle Care
3. Remove the taillamp cover
from the lamp assembly by
pulling rearward from the top
to unfasten from snap tabs.
4. Remove the two screws from the
taillamp assembly.
5. Pull the taillamp assembly
straight back to remove.
A. Turn Signal Lamp
B. Back-Up Bulb/Socket
6. Turn the turn signal lamp (A)
bulb socket counterclockwise
to remove it from the taillamp
assembly.
7. Pull the bulb straight out from
the socket.
8. Press a new bulb into the
socket, insert it into the taillamp
assembly and turn the bulb
socket clockwise until it clicks.
9. Reinstall the taillamp assembly
and tighten the screws.
10. Reinstall the taillamp cover by
snapping it into place.
11. Push the push pin to secure
the taillamp cover.
To Next Page
Loading...
