Some vehicles have funnel-shaped caps on the adjusters for easier access of a Number 2 Phillips screwdriver
to turn the adjusters.
8. For the base vehicle, turn the vertical adjuster (V1) until the headlamp beam is aimed to the horizontal tape
line. Turn it clockwise or counterclockwise to raise or lower the angle of the beam.
For the up-level vehicle, turn the vertical adjusters (V1 and V2) simultaneously until the headlamp beam is
aimed to the horizontal tape line. Turn them clockwise or counterclockwise to raise or lower the angle of the
beam.
9. Make sure that the light from the headlamp is positioned at the bottom edge of the horizontal tape line. The
lamp on the left (A) shows the correct headlamp aim. The lamp on the right (B) shows the incorrect headlamp
aim.
10. Repeat Steps 7–9 for the opposite headlamp.
To Previous Page
Loading...
