Cadillac SRX 2012 - License Plate Lamp; Replacement Bulbs

Black plate (40,1)
Cadillac SRX Owner Manual (Include Mex) - 2012
10-40 Vehicle Care
License Plate Lamp
To repl a ce one of the s e bulb s :
1. Open the liftgate. See Liftgate
on page 2�14 for more
information.
Passenger Side Shown,
Driver Side Similar
2. Push the left end of the lamp
assembly towards the right.
3. Turn the lamp assembly down to
remove from liftgate.
A. Bulb Socket
B. Bulb
C. Lamp Assembly
4. Turn the bulb socket (A)
counterclockwise to remove
from lamp assembly (C).
5. Pull the bulb (B) straight out of
the bulb socket.
6. Push the replacement bulb
straight into the bulb socket and
turn the bulb socket clockwise
to install into lamp assembly.
7. Turn the lamp assembly into the
liftgate engaging the clip side
first.
8. Push on the lamp side opposite
the clip until the lamp assembly
snaps into place.
Replacement Bulbs
Exterior Lamp
Bulb
Number
Back�up Lamp
Hyperclick
PH16W
Daytime
Running Lamp
7443
Headlamp
High-Beam
9005
Headlamp
Low-Beam
H10
License Plate Lamp 194LL
Turn Signal Front 7440
Tail/Tu r n
Signal Rear
W21W
For replacement bulbs not listed
here, contact your dealer.
Information Provided by: