Vehicle Care 10-31
11. Push the push pin to secure
the taillamp cover.
Back-Up Lamps
This vehicle has LED back‐up and
rear fog lamps. For replacement of
these lamps, contact your dealer.
License Plate Lamp
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2-11.
Passenger Side Shown, Driver
Side Similar
2. Push the left end of the lamp
assembly toward the right.
3. Turn the lamp assembly down to
remove it from the liftgate.
4. Turn the bulb socket (1)
counterclockwise to remove it
from the lamp assembly (3).
5. Pull the bulb (2) straight out of
the bulb socket.
6. Push the replacement bulb
straight into the bulb socket and
turn the bulb socket clockwise to
install into the lamp assembly.
7. Turn the lamp assembly into the
liftgate, engaging the clip side
first.
To Next Page
Loading...
