Vehicle Care 267
2. Remove the push pin (1) on
the taillamp cover (2).
3. Remove the taillamp cover
from the lamp assembly by
pulling rearward from the top to
unfasten the snap tabs.
4. Remove the two screws from
the taillamp assembly.
5. Pull the taillamp assembly
straight back to remove.
6. Turn the turn signal lamp bulb
socket counterclockwise to
remove it from the taillamp
assembly.
7. Pull the bulb straight out from
the socket.
8. Press a new bulb into the
socket, insert it into the taillamp
assembly, and turn the bulb
socket clockwise until it clicks.
9. Reinstall the taillamp assembly
and tighten the screws.
10. Reinstall the taillamp cover by
snapping it into place.
11. Push the push pin to secure
the taillamp cover.
Back-Up Lamps
To replace one of these bulbs:
1. Open the liftgate. See Liftgate
0 37.
To Next Page
Loading...
