Entering the Personalization Menu
To enter the personal settings mode, do the
following:
1. Turn the ignition to either on, Acc. (accessory),
or in Retained Accessory Power (RAP). See
“Ignition Positions” in the Index of your
vehicle’s owner manual.
The transmission must be in either PARK (P),
or the vehicle must be stopped.
To avoid draining your vehicle’s battery, make
sure the headlamps are off. See “Headlamps”
in the Index of your vehicle’s owner manual.
2. Press any button on the appropriate keyless
access transmitter to identify yourself as
Driver 1 or Driver 2. The driver number
is shown on the back of the keyless access
transmitter.
3. Press the CONFIG hard key.
4. Touch the Vehicle screen button.
5. Access the Personal Menu Setting by
pressing the Personal Settings screen button.
6. The appropriate driver information should be
highlighted. If you wish to change driver
numbers, touch the appropriate keyless
access transmitter to identify yourself as
Driver 1 or Driver 2. The system will show the
start up screen when the driver is changed.
7. The Personal Settings button must be
highlighted to continue programming. If
it is not highlighted, touch it. If it is highlighted,
touch any of the buttons on the right of the
screen to begin programming.
Some features have submenus that show
additional features that can be turned on or off.
After entering a submenu, select a feature
and scroll through the menu and make the
necessary change.
140
To Next Page
Loading...
