EasyManua.ls Logo

Cadillac XT4 2023 - Page 395

Cadillac XT4 2023
476 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cadillac XT4 Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
16412876) - 2023 - CRC - 3/25/22
394 Vehicle Care
and start to rise again as
the tire inflates with
air only.
11. Inflate the tire to the
recommended inflation
pressure using the
pressure gauge (8). The
recommended inflation
pressure can be found on
the Tire and Loading
Information label. See Tire
Pressure 0 372.
The pressure gauge (8)
may read higher than the
actual tire pressure while
the compressor is on. Turn
the compressor off to get
an accurate pressure
reading. The compressor
may be turned on/off until
the correct pressure is
reached.
Caution
If the recommended
pressure cannot be reached
after approximately
25 minutes, the vehicle
(Continued)
Caution (Continued)
should not be driven farther.
The tire is too severely
damaged and the tire
sealant and compressor kit
cannot inflate the tire.
Remove the power plug
from the accessory power
outlet and unscrew the
inflating hose from the tire
valve. See Roadside
Assistance Program 0 439.
12. Press the on/off button (5)
to turn the tire sealant and
compressor kit off.
The tire is not sealed and
will continue to leak air
until the vehicle is driven
and the sealant is
distributed in the tire.
Therefore, Steps 13
21 must be done
immediately after Step 12.
Be careful while handling
the tire sealant and
compressor kit as it could
be warm after usage.
13. Unplug the power plug (9)
from the accessory power
outlet in the vehicle.
14. Turn the sealant/air
hose (2) counterclockwise
to remove it from the tire
valve stem.
15. Replace the tire valve
stem cap.
16. Remove the tire sealant
canister (4) from the slot
on top of the
compressor (6).
17. Turn the air only hose (10)
counterclockwise to
remove it from the tire
sealant canister inlet
valve (1).
18. Turn the sealant/air
hose (2) clockwise onto the
sealant canister inlet
valve (1) to prevent sealant
leakage.
19. Return the air only hose
(10) and power plug (9)
back to their original
storage location.

Table of Contents

Related product manuals