Cadillac XT4 Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
16412876) - 2023 - CRC - 3/25/22
Vehicle Care 411
13. Disconnect the negative (-)
terminal connector from
the 12–volt battery.
14. Close and latch the hood.
Unloading from the Dolly
1. On level ground open
the hood.
2. Connect the negative (-)
terminal connector to the
12–volt battery.
3. Close the hood.
4. Follow the dolly
manufacturer's
instructions for preparing
the vehicle and dolly for
unloading.
5. Unsecure the vehicle from
the dolly.
6. Start the engine.
7. Shift the transmission to
R (Reverse).
8. Drive vehicle off of the
dolly.
9. Shift the transmission to
P (Park).
10. Apply the brake pedal and
hold until step 12.
11. Push and hold the EPB
switch for 5 seconds.
12. The EPB amber telltale in
the IP cluster will go out.
13. Apply and release Parking
Brake by pushing the EPB
switch.
Towing the Vehicle from
the Rear
Caution
Towing the vehicle from the
rear could damage it. Also,
repairs would not be
covered by the vehicle
warranty. Never have the
vehicle towed from the rear.
Do not tow the vehicle from
the rear.