Cadillac XT4 2023 - Page 414

Cadillac XT4 Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
16412876) - 2023 - CRC - 3/25/22
Vehicle Care 413
Recommend water only.
A pressure washer may be
used, but care must be utilized.
The following criteria must be
followed:
.
Water pressure must be
kept below 14 000 KPa
(2,000 PSI).
.
Water temperature must be
below 80 °C (180 °F).
.
Spray nozzle with a
40 degree wide angle spray
pattern or wider must
be used.
.
Nozzle must be kept at least
30 cm (1 ft) away from all
surfaces.
Finish Care
Application of aftermarket
clearcoat sealant/wax is not
recommended. If painted
surfaces are damaged, see
your dealer to have the
damage assessed and
repaired. Foreign materials
such as calcium chloride and
other salts, ice melting agents,
road oil and tar, tree sap, bird
droppings, chemicals from
industrial chimneys, etc., can
damage the vehicle's finish if
they remain on painted
surfaces. Wash the vehicle as
soon as possible. If necessary,
use non-abrasive cleaners that
are marked safe for painted
surfaces to remove foreign
matter.
Occasional hand waxing or
mild polishing should be done
to remove residue from the
paint finish. See your dealer
for approved cleaning
products.
Do not apply waxes or
polishes to uncoated plastic,
vinyl, rubber, decals, simulated
wood, or flat paint as damage
can occur.
Caution
Machine compounding or
aggressive polishing on a
basecoat/clearcoat paint
finish may damage it. Use
only non-abrasive waxes and
(Continued)
Caution (Continued)
polishes that are made for a
basecoat/clearcoat paint
finish on the vehicle.
To keep the paint finish
looking new, keep the vehicle
garaged or covered whenever
possible.
Protecting Exterior Bright
Metal Moldings
Caution
Failure to clean and protect
the bright metal moldings
can result in a hazy white
finish or pitting. This damage
would not be covered by the
vehicle warranty.
The bright metal moldings on
the vehicle are aluminum,
chrome, or stainless steel. To
prevent damage always follow
these cleaning instructions:
.
Be sure the molding is cool
to the touch before applying
any cleaning solution.