274 Vehicle Care
4. Disconnect the wiring harness
connector from the bulb.
5. Install the new bulb in the
headlamp assembly by turning
clockwise.
6. Reconnect the wiring harness
connector.
7. Install the headlamp bulb
access cover.
Turn Signal Lamp
1. Open the hood. See
Hood 0 256.
2. Remove the turn signal lamp
bulb socket from the headlamp
assembly by turning
counterclockwise.
3. Remove the bulb from the bulb
socket by pulling it straight out.
4. Install the new bulb in the bulb
socket.
5. Install the bulb socket into the
headlamp assembly by turning
clockwise.
Back-Up Lamps
1. Locate the back-up lamp
assembly underneath the rear
fascia.
2. Remove the bulb from the lamp
assembly by turning it
counterclockwise and pulling
straight out.
3. Remove the bulb and replace.
4. Reverse Steps 2 and 3 for
assembly.
Electrical System
Electrical System
Overload
The vehicle has fuses and circuit
breakers to protect against an
electrical system overload.
When the current electrical load is
too heavy, the circuit breaker opens
and closes, protecting the circuit
until the current load returns to
normal or the problem is fixed. This
greatly reduces the chance of circuit
overload and fire caused by
electrical problems.
Fuses and circuit breakers protect
power devices in the vehicle.
Replace a bad fuse with a new one
of the identical size and rating.
If there is a problem on the road and
a fuse needs to be replaced, the
same amperage fuse can be
borrowed. Choose some feature of
the vehicle that is not needed to use
and replace it as soon as possible.
To Next Page
Loading...
