16
Cover removal
Hold either the left or the right end
of the box up and at an angle. Use
body for stabilizing relay box.
Insert screwdriver and push tab
inward, cover should release from
base.
Roll cover off base.
Mounting: Do not mount to a surface that exceeds 115°F (45°C). The unit must
be only located in dry interior locations. Use only copper conductor supply wire
suitable for at least 105° C. All circuits must have a common disconnect and be
connected to the same pole of the disconnect. It is not suitable for installation
in hazardous locations.
To Next Page
Loading...
Need help?
General
