' &"
! "#$
%&&
Lerchenfeldstr. 9
87600 Kaufbeuren
Tel.: +49(0)8341 / 9764-0 Fax: +49(0)8341 / 67806
36
Terminal 5 Output for charging control
Terminal 6 Output for Tremat signal
Terminal 7 Control connection for pump relay
Terminal 8 Control connection for waste water tank heating relay
Insert the 12-pole ribbon cable into the socket provided on the device. The flat
cable can only be inserted into the correct socket on the device when in the
correct position. Do not use any force.
7-pole flat plug
Plug the 7-pole flat cable into your control panel. The assignation of the
contacts is according to the following list:
Fig. 7: 7-pole connector
Terminal 1 Waste water tank com.
Terminal 2 Waste water tank ¾
Terminal 3 Fresh water tank com.
Terminal 4 Fresh water tank ¼
Terminal 5 Fresh water tank ½
Terminal 6 Fresh water tank ¾
Terminal 7 Fresh water tank 1/1
Insert the 7-pole ribbon cable into the socket provided on the device. The flat
cable can only be inserted into the correct socket on the device when in the
correct position. Do not use any force.
To Next Page
Loading...
