' &"
! "#$
%&&
Lerchenfeldstr. 9
87600 Kaufbeuren
Tel.: +49(0)8341 / 9764-0 Fax: +49(0)8341 / 67806
37
Connection to the fresh water tank
Plug the 5-pole flat cable into your fresh water tank. The assignation of the
contacts is according to the following list:
Terminal 1 Com.
Terminal 2 1/4
Terminal 3 1/2
Terminal 4 3/4
Fig. 8: 5-
Terminal 5 1/1
Connection to the waste water tank
Plug the 2-pole flat cable into your waste water tank. The assignation of the
contacts is according to the following list:
Terminal 1 Com.
Fig. 9: 2-
Terminal 2 3/4
Temperature sensor, changeover switch battery type
Fig. 10
If you are using a temperature sensor for the battery II,
fasten the temperature sensor to the face of the battery II
(supply battery).
To do so, remove the protective plastic
film from t
he Velcro strip of the temperature sensor
fixture and press it firmly to the desired position on
battery II (see description of temperature sensor).
Connect the cable of the temperature sensor to the
temperature sensor connection (fig. 10, 2-
connection) of the device.
To Next Page
Loading...
