What to do if I have low UV intensity in my CalUltra Water Filtration System?
If you are experiencing low UV intensity, you should remove and clean the quartz sleeve and sensor. Verify that the water quality meets the requirements outlined on page 5 and enhance filtration if needed. Also, consider replacing the lamp.
How to fix a lamp problem detected by my CalUltra Water Filtration System?
To address a detected lamp problem, try resetting the lamp protection circuit by unplugging the unit for 10 seconds. If the issue persists, replace the lamp with the correct part. You can find the part number on the silver label on the unit or on the Maintenance parts screen.
Why is my CalUltra Water Filtration System lamp not disinfecting properly even though it's on?
Even if the lamp is lit, its UV output may be insufficient for proper disinfection due to its age. Replace the lamp with the correct part. You can find the part number on the silver label on the unit or on the Maintenance parts screen.
General| Brand | CalUltra |
|---|---|
| Model | UV-CalUltra 12 |
| Category | Water Filtration Systems |
| Language | English |
Tools and materials required for installing the UV system.
Essential water quality parameters for effective UV disinfection.
Identification of components included with the CalUltra domestic units.
Guidance on selecting the correct UV unit size and optimal installation site.
Instructions for reactor mounting, by-pass assembly, and flow restrictor use.
Procedures for installing the quartz sleeve, UV sensor, and IEP port.
Mounting the controller and connecting the UV lamp and its components.
Steps to disinfect home water lines using bleach and the UV system.
Step-by-step guide for cleaning the quartz sleeve.
How to clean the UV sensor using isopropyl alcohol.
Overview of controller capabilities and interpreting system status displays.
LCD screen details, diagnostic start-up, and module checks.
Display screens for system status, modules, and UV intensity.
Visual and audible alerts for UV output levels and lamp replacement timing.
Steps for replacing an expired UV lamp with a new one.
How to use QR codes on the controller for website links and info.
Troubleshooting hard alarms indicated by constant audible alarms.
Troubleshooting soft alarms and water safety advice during failures.
Devices for temperature control and the Infinite Expandability Port.
Details on Remote Alarm, Solenoid, 4-20mA, and Ethernet modules.
Detailed specifications for CalUltra standard output systems.
Warranty periods, terms, and conditions for product use.
Procedure for obtaining warranty service and returning defective products.
Detailed specifications for CalUltra commercial/industrial systems.
To Next Page