CAME A 3024 N - Page 6

6
ENGLISH
The data and information shown in this manual may be changed by CAME cancelli automatici s.p.a. at any time without prior warning.
Unscrew the two securing screws and remove the carter.
Unscrew the two securing screws and remove the stem.
N.B.: we suggest lubricating (using neutral grease) the endless screw and the bushing upon installation.
Begin mounting the gearmotor to the two brackets.
M8 self-locking nut
Endless screw
Carter
Stem
5.7 Securing and adjusting the endstop
Spindle
Endless screw
Closing-speed brake
microswitch
Microswitch bar
Spindle
Cable support
Microswitch actuating sled
Stop brake micro-
switch
M8x10
M8x50