CAME AGT A200K - HA;200 Audio Module Functions; HA;200 Trimmer Adjustments; HA;200 Technical Specifications

1
2
3
Ⓐ
Ⓑ
󱫂󱫄
󱫀
Page 6 - Manual FA0142 5- EN - 08/2020 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
HA/200
Trimmers 󱫀
Ⓐ Speaker audio
Ⓑ Microphone audio
Technical data
Type HA/200
Power supply (VDC) 12
Max power consumption (mA) 50
Power consumption in stand-by (mA) <35
Storage temperature (°C) -25 to +70
Operating temperature (°C) -15 to +50
IP Rating IP54
Installation
• The device can be installed on DIN rails (EN 50022) on a
suitable switchboard, or on the wall using the terminal covers.
• To dismantle the device, proceed as shown in fi gure 2-3.
• See fi gure 1 for dimensions.
The power supply must always be installed horizontally.
Ensure there is correct ventilation if the power supply is
installed in a metal case.
Description
Audio module.
Functions of terminals and audio adjusters
Terminal board 󱫀
5 – power supply
21 + 12 VDC
8 common call (for call beep)
11 audio to internal receiver
12 audio from internal receiver
14 enable
In systems in which there is an enable command, terminal
14 can be connected to the earth (unit always active) or to
terminal 12 (unit active only when handset is raised).