F
G
H
I
Page 27 - Manual FB01002-EN - ver. 1 - 11/2017 - © CAME S.p.A. - The contents of this manual are subject to change at any time without prior notice.
Use the buttons to choose
the desired program from: P1, P2,
P3, F (see graph and table L);
press button P to confirm your
choice and end programming.
The first parameter concerns
the duration of the power-on
cycles G.
Use the
buttons to choose
the duration of the cycle - 5,
10, 15, 20, 25, 30, 35 or 40
minutes H.
Press button P Ito confirm
the set cycle time and switch to
adjusting the minimum ON time.
Use the
buttons to choose
the minimum ON time between
1 and 5 minutes.
If you have chosen the P4 program, pressing button P gives access to the programming
of the individual parameters that make up the manual P4 program.
To Next Page
Loading...
