0.2 03/2010
© CAME cancelli automatici s.p.a. -
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
(N.C.) contact for «re-open during closing phase»
- Input for safety devices such as photocells, sensitive edges and other
EN 12978 compliant devices. When bar leaves are closing, opening
the contact causes reversal until total opening is obtained.
If not used, short circuit contact 2-C1.
DIR photocells
Safety devices
6.3 Adjusting movement and deceleration speeds
To adjsut the opening and closing
speed, move transformer faston
labeled “A” to
[Velocità] -> [Min.]/[Med.]/[Max.].
To adjsut the decelerations, move
the faston “B” to
[Rallentam.] -> [Min.]/[Max.].
Black
White
Red
Open barrier warning light (contact rating: 24V – 3W max.)
- Signals when bar is in ‘up’ position, turns off once bar is down.
Flashing Crown and/or Luminous band (Contact rating: 24V - 32W max.) - Flashes when bar is opening and closing.
Warning devices
[Min.] = minimum
[Med.] = medium
[Max.] = maximum
To Next Page
Loading...
