CAME GLT40AOS - Page 13

Page 13 - Manual FA01748-EN - 04/2023 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
Tighten the screws using a torque wrench and a torque of 20 Nm.
Choosing the hole for fixing the balance spring
Passage width clearance (m) 2,00 < 2,25 2,25 < 2,75 2,75 < 3,25 3,25 < 3,50 3,50 < 3,75 3,75 < 4,00
Boom -
1 1 1 2 2
Boom with anti-collision profile and LED strips
1 1 2 2 3 3
Boom with single skirt
1 2 3 3
--
Boom with swing rest
2 2 2 3 3
-
Boom with anti-collision profile and swing rest
2 2 3
---
If the passage is wider than 3 m, you must use a support for the boom (fixed or mobile).
Single skirt (803XA-0340):
- max 2 modules for a 4 metre boom