CAME GLT40AOS - Electrical Connections; Power Supply

Page 19 - Manual FA01748-EN - 04/2023 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
ELECTRICAL CONNECTIONS
Passing the electrical cables
Connect all wires and cables in compliance with the law.
The electrical cables must not touch any parts that may overheat during use (such as the motor and transformer).
Make sure that the moving mechanical parts are suitably far away from the wiring.
Power supply
Make sure the mains power supply is disconnected during all installation procedures.
Before working on the control panel, disconnect the mains power supply and remove the batteries, if any.
Connecting to the electrical network
F
Line fuse
L
Phase wire
N
Neutral wire
Earth wire
F
230 V AC
50/60 Hz
Power supply output for accessories
The output normally delivers 24 V AC.
10 11 E1 TS 1 2 3 3P 4 5 7 2 CX CY CZE
1
T
S
1
2
3
3P
P
4
5
7
2
CX
X
C
Y
Y
CZ
Z