CAME GLT40AOS - Signalling Devices; Safety Devices

Page 21 - Manual FA01748-EN - 04/2023 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
Signalling devices
1
Additional light
It increases the light in the manoeuvring area.
See function [F18].
2
Additional flashing beacon
It flashes when the operator opens and closes.
See function [F18].
3
Operator status warning light
It notifies the user of the operator status.
See function [F10].
4
LED strip
See function [F15].
10 11 E1 TS 1 2 3 3P 4 5 7 2 CX CY CZ
3
1
+R
G
Safety devices
Connect the safety devices to the CX, CY and/or CZ inputs (NC contacts).
During programming, configure the type of action that must be performed by the device connected to the input.
If contacts CX, CY and CZ are not used, they must be deactivated during programming.
DELTA photocells
Standard connection
Multiple photocell pairs can be connected.
DELTA photocells
Connection with safety test
Multiple photocell pairs can be connected.
See function [F5] Safety devices test.
10 11 E1 TS 1 2 3 3P 4 5 7 2 CX CY CZ
+
10
-
11 NO C NC
+
10
-
11
RX TX
10 11 E1 TS 1 2 3 3P 4 5 7 2 CX CY CZ
+
10
-
11 NO C NC
+
10
-
11
RX TX