CAME GUARDIAN Series - 7 Electric wiring; 7.1 Cable type and section; 8 Control panel; 8.1 General description

Pag.
20
20 - Manual code:
119G3055
119 G30 55 ver.
1.0
1.0 10/2009 © CAME cancelli automatici s.p.a. - The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
Position the control panel inside the traverse piece to then connect to the cables.
Thread the control panel and accessories power cable along the entire height of the column through the hole all the way up the
traverse piece.
Control panel
Power cable
LED stop/go lights
7 Electric wiring
From the traverse piece, thread the two ends of the fl at wire through the holes on the side of the traverse piece and connect to the
traffi c lights. Connect the central fl at-wire plug to the board socket. (see electrical connections).
Note: the above descriptions and illustrations refer to the single model. The
double model requires double cabling.
LED stop/go lights
Control
panel
Control
panel
Metal
strips
Intelligent Security & Fire Ltd.