3
2
1
2
4
Pag.
- Manual code:
119 G30 55 ver.
1.0 10/2009 © CAME cancelli automatici s.p.a. - The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
5 Installing a single opening
Only skilled, qualified staff must perform the installation, in full compliance of the current legislation.
5.1 Preliminary checks
Make sure you have all the tools and materials needed to carry out the installation in total safety and in compliance with current
legislation. The figures shows examples of installers’ tools.
5.2 Tools and materials
Before installing the automated device, please:
• Set up a proper omnipolar cut-off device, with contacts more than 3 mm apart, and power source isolation;
• Set up proper tubing and conduits for the electrical cables to go through with enough protection from any mechanical
damage;
•
Check that any connections within the container (made to give continuity to the protection circuit) have additional isolation
compared to the other internal power conductors.
• Check that the transit entrance area in a proper state and free of any slumps, otherwise apply the required (L=1800 mm x
L=1600 mm x H=120 mm) RCK300 cement base, which ensures proper securing of the turnstile.
1) Automated operator
2) Fence
3) Junction pit
4) Direction indicator
5.3 Standard installation
Intelligent Security & Fire Ltd.
To Next Page
Loading...
