CAME LHS V/01 PLUS - Programming Entry Panels with VA;01 and A;01; Entering Programming Mode; Programming Call Buttons; Programming Calls

Page 21 - Manual FA01639-EN - 12/2021 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
PROGRAMMING ENTRY PANELS WITH VA/01 AND A/01
Entering programming mode
+
–
M1
+
PROG
Press and hold the power supply unit [PROG] button for at least 3 seconds.
The LEDswill fl ash together with the [P1-P4] button LEDs.
The [PROG] LED on the power supply unit and entry panel turn on and stay on.
Programming call buttons
Press [P1] to confi gure 2 x two-way buttons (max 4 calls).
Press [P2] to confi gure two single buttons (max 2 calls).
The
LED and the call button LEDs will stop fl ashing.
Programming calls
1
2
In [Programming calls], the LED and the [PROG] LEDs fl ash.
The call button LEDs will remain on.
In a system with multiple entry panels, you can only program one entry panel at a time only, identifi ed by the lit
LED.
On the remaining entry panels, the LED will remain on.